HGM8110A/8120A Genset Controller User Manual Page 23 of 57
No.
Type
Description
16
Gen Loss of Phase
When controller detects the generator loss phase, it will send
warn signal.
17
Gen Reverse Phase
Sequence
When controller detects the reverse phase, it will send warn
signal.
18
Switch Fail Warn
When controller detects the switch on and off fail, and the
action is selected enable, it will send warn signal.
19
Temp. Sensor Open
When controller detects the sensor is open circuit, and the
action selects “Warning”, it will send warn signal.
20
High Temp. Warn
When controller detects the temperature is higher than the set
value, it will send warn signal.
21
Low Temp. Warn
When controller detects the temperature is lower than the set
value, it will send warn signal.
22
OP Sensor Open
When controller detects the sensor is open circuit, and the
action selects “Warning”, it will send warn signal.
23
Low OP Warn
When controller detects the oil pressure is lower than the set
value, it will send warn signal.
24
Level Sensor Open
When controller detects the sensor is open circuit, and the
action selects “Warning”, it will send warn signal.
25
Low Level Warn
When controller detects the level is lower than the set value, it
will send warn signal.
26
Flexible Sensor 1 Open
When controller detects the sensor is open circuit, and the
action selects “Warning”, it will send warn signal.
27
Flexible Sensor 1 High
When controller detects the sensor value is higher than the
max. set value, it will send warn signal.
28
Flexible Sensor 1 Low
When controller detects the sensor value is lower than the min.
set value, it will send warn signal.
29
Flexible Sensor 2 Open
When controller detects the sensor is open circuit, and the
action selects “Warning”, it will send warn signal.
30
Flexible Sensor 2 High
When controller detects the sensor value is higher than the
max. set value, it will send warn signal.
31
Flexible Sensor 2 Low
When controller detects the sensor value is lower than the min.
set value, it will send warn signal.
32
Digital Input Warn
When digit input port is set as warning and active, controller
sends corresponding warning signal.
