HGM6000K Series Automatic Generator Module
HGM6000K Series Automatic Generator Module ISSUE 2011-06-20 Version 1.7 Page 25 of 34
7.2 OUTPUT 1-4 TABLE (TABLE 2)
Num
Content
Description
0
Not used
Output is no use when select this
1
Common alarm
The designated programmable output relay
will energize when any warning or shutdown
fault circuit has been activated.
2
ETS solenoid hold
The designated programmable output relay
will energize when a stop signal has been
activated. The output will remain ETS
solenoid for pre-set timer once the engine
has come to a complete stop, then
de-energizes.
3
Idle control
The designated programmable output relay
will energize when the idle delay is not zero.
The output contact would typically be
connected to the “idle/run” input control of an
electronic governor.
4
Preheat control
The designated programmable output relay
will energize during the preheat delay timer
period and also energize until the engine
receive a crank success signal. The preheat
output is typically used for an engine starting
aid such as glow plugs.
5
Close Gens
Switch genset breaker on.
6
Close Mains
Switch mains breaker on.(HGM6010KC)
7
Open ATS
When closing time set to zero, time off to
continue, this function when the feeder,
namely for continues when closed on, does
not have this function.
8
Raise speed
control
In the process of warm-up when he entered
the suction, suck time for high-speed
warm-up delay time. Raise speed auxiliary
input effective disconnect.
9
Drop speed control
Enter into stop idling process or to ETS
solenoid stop (when alarm stop) sucked, and
suck time to stop idling delay time. Drop
speed when the auxiliary valid disconnect.
10
Pre-supply oil
control
11
High speed output
High speed warm-up, ready to on-load,
normal operating, output after high speed
cooling.
