30
SMARTEK Vision | User Manual
– LED Strobe Controller Family | Doc. v2.2.1
5.2. IPSC-Series
On the devices of the IPSC-series, there are 4 status LEDs on the front panel:
Identifier
Color
Type
IPSC1
IPSC2
IPSC4
PWR
P
POWER
Green
POWER
ERR
E
FAULT
Red
FAULT
STR
S
STROBE
Yellow1
STROBE
ARM
A
ARMED
Yellow2
ARMED
Table 24: IPSC - Identification of status LEDs on different models
When powering the device, POWER (green) and STROBE (yellow) LEDs are constantly ON,
and the FAULT (red) LED is flashing for 5 seconds. After the startup process is completed, only
the POWER (green) LED stays persistently ON.
The different LED status are shown in Table 25.
Type
Status
POWER (green) LED
Solid on
Controller is powered
FAULT (red) LED
Flashing in specific intervals
System has a failure
Flashing (in combination with STROBE (Yellow) LED)
Controller is starting up, setting controller's IP address,
updating firmware. The controller is in reboot mode
STROBE (yellow) LED
Flashing
Indicates the pulse coming from the IPSC's output. The
duration of the LED being turned on depends of the
pulse length
Solid on
The controller is either in Continuous or External Switch
mode. IPSC is driving outputs with continuous currents
ARMED (yellow) LED
Solid on
Indicates voltage on output (ready for triggering pulses
or in continuous mode)
Table 25: IPSC - Status LEDs and description
5.2.1.
Ethernet Status
The Ethernet connector provides a
yellow
and a
green
LEDs, where the
green
LED indicates
link, the
yellow
one activity.
Green LED (left)
Status
OFF
No link
Solid on
Link on / Ethernet link exists
Yellow LED (right)
Status
OFF
No activity
Flashing
Indicates ongoing activity
Table 26: IPSC Ethernet status LED
