32
SMARTEK Vision | User Manual
– LED Strobe Controller Family | Doc. v2.2.1
6. Getting Started
The following section describes the required components and a generalized procedure to put
a Strobe Controller of the HPSC or IPSC series into operation. Figure 21 shows a simplified
setup, whose single components are described in the following chapter.
6.1. System Requirements
(1)
SMARTEK
Vision Strobe Controller of IPSC- or HPSC-Series
(2)
Power Supply
with flying leads and ferrules
o
IPSC1 / 2:
12V to 24V DC with at least 84W
o
IPSC4 / HPSCx: 12V to 24V DC with at least 135W / 150W
(3)
Cable for communication
:
o
Ethernet: Patch cable with RJ45 plugs; IPSC-Series/HPSC1: Direct connections to
10/100 Mbit network cards require a crossover cable
o
Serial:
RS-232 straight-through cable with male to female 9-pole D-Sub plugs
o
USB:
USB2.0 A-to-B cable
(4)
Cable for powering the illumination
o
IPSC-Series:
Power-out cable for IPSC series providing an appropriate number
of lines. Assembled cables are available as accessory from our
sales partners.
o
HPSC-Series:
Flying leads can be directly attached to the devices screw terminal,
Note:
Shielded cables (grounded at illumination) are strongly recommended, further
suggestions can be found in Chapter 1.3.
Figure 21: Basic setup with an IP Strobe Controller
