e.g.
l
IP – 192.168.0.30,
l
Subnet Mask- 255.255.255.0
l
Default Gateway- 192.168.0.1
4.Click OK and click OK again in the Network window.
5.Restart the computer if asked.
Setting the Temporary IP Address to airPoint-PRO Outdoor
1.start the DOS prompt on your Windows PC.
2.Please note down MAC No. of your airPoint-PRO Outdoor.(The MAC Address label is pasted on
the bottom of the airPoint-PRO Outdoor)
3.MAC No. is a HEX no.(0-9, A-F) so Please make sure when typing that you are not typing English
alphabet "O" instead of numeric "0" (Zero).
4.Type the following command in the DOS Prompt window:(Replace xx-xx-xx with the actual MAC
No. of your airPoint-PRO Outdoor)
5.arp -s 192.168.0.24 00-30-1A-xx-xx-xx
If the Temporary IP Address is set Properly you should be able to Ping the airPoint-PRO Outdoor
.
1.start the DOS prompt on your Windows PC.
2.Type the following command in the DOS Prompt Window:
3.ping 192.168.0.24
4.If you get the ping response without error the Temporary IP is set.
5.Once you have completed the airPoint-PRO Outdoor Configuration, you can set the PC back to
its previous
6.Mode and delete the temporary IP Address assigned to airPoint-PRO Outdoor.
Restoring the Original IP Configuration of PC
1.Follow steps 1 and 2 in the instructions in "Setting the Temporary IP Address to the PC".
2.Select either Specify an IP address or Obtain IP address automatically and enter in the original
values you noted earlier.
3.Click OK and click OK again in the Network window.
4.Restart your computer.
Deleting the Temporary IP Address assigned to airPoint-PRO Outdoor:
1.start the DOS prompt on your Windows PC.
2.Type the following command in the DOS Prompt Window:
3. arp -d 192.168.0.24
NOTE :- Temporary IP Address can be assigned to airPoint-PRO Outdoor
only within first 3 minutes after airPoint-PRO Outdoor is Powered ON.
Configuring the airPoint Outdoor
Configuring airPoint Outdoor Connected to the Ethernet LAN
By Default airPoint Outdoor runs a DHCP Client. So the IP Address will be acquired from the
DHCP Server. If your LAN doesn't have a DHCP server but instead you run the PCs with Static IPs
then you need to assign a Temporary IP Address to airPoint in order to configure it (see Appendix
A for detailed instructions).
Configuring airPoint Outdoor using a standalone PC
Connect the airPoint Outdoor to your PC using cross Ethernet cable. You can convert straight
Ethernet cable to cross using a cross connector provided. Make sure the power to the airPoint
