l
Click Set Power button. This will change the radio
transmit power of the airPoint-PRO Outdoor unit.
l
It is recommended to operate the unit with
minimum required power to reduce the
interference to other installations.
Restore Factory Default Settings
If you forget the critical settings like WEP or Administrator Password of the airPoint-PRO Outdoor,
you can restore the airPoint-PRO Outdoor to the Factory Default Settings as,
1. Make sure that the Power to the airPoint-PRO Outdoor is ON. ( indicated by PWR LED )
2. Locate and Press the Restore Defaults Button on powerShot-SB2811 continuously
(The button is at the bottom side and can be accessed by a small pin).
3. The TxRx LED will stop flashing for few seconds.
4. Release the button after the TxRx LED starts flashing again.
5. After restoring the Factory Default Settings, please configure the airPoint-PRO Outdoor again.
Appendix A
Assigning the Temporary IP Address to airPoint-PRO Outdoor
1.start the DOS prompt on your Windows PC.
2.Please note down the MAC No. of your airPoint-PRO.( The MAC Address label is pasted on the
bottom of the airPoint-PRO Outdoor )
3.MAC No. is a HEX no.(0-9, A-F) so Please make sure when typing that you are not typing English
alphabet "O" instead of numeric "0" (Zero).
4.Please get the Temporary "IP Address" to be assigned to airPoint-PRO Outdoor from your LAN
Administrator.
5.Type the following command in the DOS Prompt window:(Replace xx-xx-xx with the actual MAC
No. of your airPoint-PRO Outdoor)
6.arp -s IP Address 00-30-1A-xx-xx-xx
7.For more help about arp command type "arp/?" in the DOS Prompt window.
If the Temporary IP Address is set Properly you should be able to Ping the airPoint-PRO Outdoor.
1.start the DOS prompt on your Windows PC.
2.Type the following command in the DOS Prompt Window:
3.ping IP Address
4.If you get the ping response without error the Temporary IP is set.
Once the configuration of airPoint-PRO Outdoor is over please delete the Temporary IP Address
assigned to airPoint-PRO Outdoor.
Deleting the Temporary IP Address assigned to airPoint-PRO Outdoor
1.start the DOS prompt on your Windows PC.
2.Type the following command in the DOS Prompt Window:
3.arp -d IP Address
NOTE :- Temporary IP Address can be assigned to airPoint-PRO Outdoor
only within first 3 minutes after airPoint-PRO Outdoor is Powered ON.
Appendix B
Setting the Temporary IP Address to the PC
Click on Start -> Settings -> Control Panel, then Network.
1.Click on the network adapter associated with the TCP/IP and click Properties.
2.Note your current settings in order to restore your TCP/IP configuration.
3.Select Specify an IP address and enter the following values as per your Network Configuration:
