IMPORTANT INFORMATION
iii
l
The SMART product should be used only with European TN and TT power distribution
systems.
It is not suitable for older, IT-type power distribution systems found in some European
countries. This system (IT-type) is widely used isolated from earth, in some installations in
France, with impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral
not distributed, at 230V line-to-line.
Contact qualified personnel if you’re uncertain of the type of power system available where
you’re installing the SMART product.
l
The accessory slot’s maximum available power is 60 W. The slot is not a limited power
source. To reduce the risk of fire, make sure that accessories connecting to the slot satisfy
the fire enclosure requirements of IEC 60950-1.
l
You must connect the USB cable that came with the SMART product to a computer that has
a USB compliant interface and that bears the USB logo. In addition, the USB source
computer must be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or
UL Mark(s) for CSA/UL 60950. This is for operating safety and to avoid damage to the
SMART product.
IMPORTANT
l
The following are the normal operating requirements for the display, including AM module
and speakers:
Model
Power requirements
SBID-MX265
100V to 240V AC, 50 Hz to 60 Hz, 115 W max
SBID-MX275
100V to 240V AC, 50 Hz to 60 Hz, 224 W max
SBID-MX286
100V to 240V AC, 50 Hz to 60 Hz, 265 W max
l
For additional requirements and other information, refer to the display’s specifications (see
Federal Communication Commission
interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
