2000i Installation Guide
13
To change the image size
1. Crouch behind the projector and look at the projected image through the view port.
Figure 16: Position for Changing the Image Size
2. Loosen the four hex screws that secure the projector to the projector plate using the 3 mm. hex
key provided in the accessory kit.
NOTE
: These screws are located on top of the projector plate, two at the front of the projector
and two at the back.
4x
Figure 17: Loosening the Four Hex Screws to Change Image Size
To access the two screws at the front of the projector, you must reach through the view
port, extend your arm to the front of the projector, and maneuver the 3 mm. hex key
through the two access holes in the projector cover.
The following figure shows the location of these two access holes from the front of the
2000i.
Image Size Adjustment
