2000I Installation Guide
10
Adjusting the Projected Image
You may need to adjust the projector to achieve a focused image that fits on the screen. Complete
the four adjustment procedures that follow only as required. For the first three, (roll, side-to-side
and image-size adjustment), you must watch the image on the back of the screen while making
adjustments. You’ll also need to remove the view port cover (attached with hook-and-loop fastener
strips) at the rear of the unit to access the adjustment hardware.
View Port Cover
Figure 10: Location of the View Port Cover
For the final procedure (adjusting the image up or down), adjust the image while watching it from
the front of the unit.
To remove the view port cover
1. Grasp the view port cover in the middle of each short edge, and pull it away from the unit.
Lift from here
Lift from here
Figure 11: Removing the View Port
You can now access the top of the projector to perform the following image-adjustment
procedures.
