SMART Board 600i3, Configuration And User'S Manual

Page: 25 / 80

99-00915-20 B0 Installing Your SMART Board 600i3 Interactive Whiteboard System 15
5. Adjust the physical size of the projected image to fit the interactive whiteboard.
a. If you haven’t already done so, loosen the large wingnut on the top of the ball joint to allow the
projector to move backward and forward in the slot.
b. Move the projector forward or backward on the boom to make the image larger or smaller.
NOTE: During this step, you may need to tilt or turn the projector slightly to keep the image square.
6. Focus the projector using the focus lever (located on the top of the projector).
NOTE: You may need to repeat all steps in smaller increments in order to fine-tune the image.
7. Tighten the large wingnut on the top of the ball joint.