ENGLISH
18
Adjusting delay times of speakers in
Dolby Digital, Dolby Pro Logic II or Dolby
Pro Logic Mode
• The delay time will be displayed for 5 seconds.
• The corresponding delay time is displayed. The
center delay time can be adjusted in the Dolby Digital
mode only.
• In case of Dolby Digital, Dolby Pro Logic II or Dolby
Pro Logic mode, when the distances from the prime
listening position to front left, center, front right, rear left
and rear right speakers are the same, the basic settings
are as follows according to the surround modes :
- In the Dolby Digital mode,
Center delay time : 0 ms, Rear delay time : 0 ms
- In the Dolby Pro Logic II Music, Matrix or Custom mode,
Rear delay time : 0 ms
- In the Dolby Pro Logic II Movie, Dolby Pro Logic mode,
Rear delay time : 10 ms
• If the center or the rear speakers are at a different
distance from the prime listening position than the front
speakers, the user can customize the delay settings to
make sure that the sound from all the speakers arrives at
the listening position at the same time. For every foot the
center or rear speakers are closer than the front speakers,
add 1 ms (one millisecond, or 1/1000 of a second) delay
to those speakers, to allow the sound the extra time to
travel to the listener to match the sound arrival time from
the main speakers (front left and front right). Sound
travels at roughly 1100 feet per second in air, but can be
estimated at 1000 feet per second to keep the math easy.
Downmixing into two front channels
• To cancel the 2-CH downmix mode, select the
desired surround mode by using the DSP MODE
button.
• When the playback of the source on the player is
stopped or interrupted, etc., the 2-CH downmix mode
is not canceled even though “ST” and the DTS or
Dolby Digital indicators go off.
• The receiver will automatically enter two channel
downmix mode if the headphones are plugged in and
the SPEAKER button is set to off, and digital
program material from DTS or Dolby is present. If
the headphones are unplugged and the SPEAKER
button is set to "on" in the 2-channel downmix mode,
the receiver will return to the previous mode.
Check the delay time to be adjusted.
17
In Dolby Digital mode, repeat the above
steps, 17 and 18, to adjust the rear delay
time.
19
• Each time this button is pressed in the Dolby Digital,
Dolby Pro Logic II or Dolby Pro Logic mode, the
delay time changes in regular intervals.
• If the delay time disappears, start from step 17 again.
Adjust the delay time.
18
• Allows the multi-channel DTS or Dolby Digital signals
to be reproduced through only two speakers or through
headphones.
• When the digital signals from the DTS or Dolby Digital
program sources are input in available surround mode,
press the STEREO button.
• “ST” (for Stereo) and the DTS or Dolby Digital indicators
light up, meaning it enters the 2-CH downmix mode, and
then the discrete multi-channels (except LFE) are mixed
down into two front channels.
Summary of Contents for Q-Line Silver
Page 1: ......
Page 6: ...5 ENGLISH...
Page 7: ...6 Front Panel Controls ENGLISH...
Page 8: ...7 Remote Controls ENGLISH...