SLS Audio Q-Line Silver, Instruction Manual

Page: 18 / 29

ENGLISH
17
Enter the test tone mode.
14
• The test tone is used to adjust each channel's level.
The test tone is not available for channels that are not
selected or not active. For example, in stereo mode,
the test tone function is not available for the rear
speakers.
Note: When the 6 CH DIRECT is selected as an input
source, the test tone function does not work.
At each channel, adjust the level as desired
until the sound level of each speaker is
heard to be equally loud.
15
Cancel the test tone function.
16
Adjusting each channel level
Adjusting each channel level with test
tone
Select the desired channel.
11
Adjust the level of the selected channel
as desired.
12
Repeat the above steps 11 and 12 to
adjust other channel levels.
13
• The LFE level can be adjusted within the range of 10
to 0 dB and other channel levels within the range of
-15 to +15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB. (However, the recommended LFE
level for some early DTS software is -10 dB.) If the
recommended levels seems too high, lower the setting
as necessary.
• If the channel display disappears, start from the above
step 11 again.
• Each time this button is pressed, the corresponding
channel is selected and displayed for 3 seconds as
follows :
Front Left Center Front Right Rear Right
(Dolby Digital or DTS L(FE) )SubWoofer Rear Left
( ): Adjustable only when the digital signals from Dolby Digital or DTS
program source that includes LFE signal are input in the available
surround mode.
• When in Stereo mode, or the speaker setting is “N”,
center, rear or subwoofer channel will not be selected.
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows;
Front Left Center Front Right
SUBwoofer Rear Left Rear Right
• When the speaker setting is “N”, the test tone of the
corresponding channel is not available.
• The test tone function is bypassed when the selected
decoding mode is not matched to the input signal format.
• You can select the desired channel and adjust its level
by repeating steps 11 and 12 in “Adjusting each
channel level” procedure.