ENGLISH
• If the parameter display disappears (after 5 seconds),
start from step three again.
Repeat steps three and four to adjust other
parameters.
5
Note:
• In Dolby Pro Logic II Custom mode, you may turn on
either 7 KHz Low Pass Filter or Shelf Filter, not both.
If so, the filter set previously is automatically
changed to OFF.
After selecting parameter with MEMO/ENTER
button, modify setting using ADJUST buttons.
4
15
When canceling the surround mode for stereo operation.
• Then the stereo mode is selected.
• To cancel the stereo mode, select the desired surround
mode using the DSP MODE button.
While scrolling “PL II MUSIC” (for Dolby Pro Logic II Music mode) or “PL II CUSTOM” (for Dolby
Pro Logic II Custom mode), press the MEMORY/ENTER button to select the desired parameter.
3
Adjusting the Dolby Pro Logic II parameters
• When selecting Dolby Pro Logic II Music and Custom modes, you can adjust the various surround parameters
for optimum surround effect.
• If the Dolby Pro Logic II Music or Custom display disappears (after 5 seconds), you cannot select the parameter.
In this case, select the desired surround mode again by pressing the DSP MODE button.
• In the Dolby Pro Logic II Music mode, you cannot select the 7 kHz Low Pass Filter, Shelf Filter, Right Surround
Channel Polarity Inversion and Automatic Balancing.
• Each time this button is pressed, the parameter changes and is displayed for five seconds as follows:
Summary of Contents for Q-Line Silver
Page 1: ......
Page 6: ...5 ENGLISH...
Page 7: ...6 Front Panel Controls ENGLISH...
Page 8: ...7 Remote Controls ENGLISH...
