3
1B - Install Faucet Spout —
EBF-650
A
Install Faucet Spout as shown.
Important: Apply thread sealant or Teflon tape to threads of Water
Supply Pipe Nipple.
Refer to the Installation Instructions included with the ETF-578-A Trim Plate
for additional information about using an 8" Trim Plate with an EBF-650
faucet.
FAUCET
1/8” NPT PIPE NIPPLE
BASE GASKET
FAUCET SENSOR CABLE
APPLY THREAD SEALANT
SLOTTED MOUNTING
WASHERS (2)
WING NUTS (2)
1/8” NPT PIPE TO 3/8” TUBE
COMPRESSION FITTING
2 - Install Solenoid Valve
A
Install 3/8 inch (10 mm) supply tube (furnished by installer) between
the Compression Fittings on Spout and the top outlet of Solenoid Valve.
Flow direction of Solenoid Valve is indicated by an arrow on Valve Body.
3/8” (10 mm) SOLENOID
VALVE COMPRESSION
FITTING (TOP OUTLET)
3/8” (10 mm) SUPPLY TUBE
(NOT SUPPLIED)
3/8” (10 mm)
COMPRESSION FITTING
Model
EBF-615
Shown
3 - Connect Supply Line(s) from Supply Stop(s) to Solenoid Valve Inlet
Dual Line Hot and Cold Water
Supply Applications
Install a 3/8 inch (10 mm) copper supply tube
between Bak-Chek
®
Compression Tee and hot
and cold supply stops. (Supply tubes and stops
furnished by installer.) Install a 3/8 inch (10 mm)
copper supply tube between Bak-Chek
Compression Tee and inlet side of Solenoid
Valve. Tighten Compression Fittings securely.
Note: Failure to install the Bak-Chek
®
Tee can
result in a cross flow connection when the
faucet is off and the supply stops are
open. If pressure of the hot and cold water
supply differ, hot water can migrate into
the cold water supply or vice-versa.
Most plumbing codes require that the
Bak-Chek
®
be used to prevent this.
3/8” (10 mm)
BAK-CHEK TEE USED
ON DUAL WATER
SUPPLY
APPLICATIONS
ONLY
3/8” (10 mm)
COMPRESSION
FITTING
3/8” (10 mm)
SUPPLY TUBE
SOLENOID
VALVE
SUPPLY
STOP
A
3/8” (10 mm)
COMPRESSION
FITTING
3/8” (10 mm)
SUPPLY TUBE
SOLENOID
VALVE
SUPPLY
STOP
B
Single Line Water Supply Applications
Install a 3/8 inch (10 mm) copper supply tube
between the supply stop and inlet side of
Solenoid Valve. (Supply tube and supply stop
furnished by installer.) Tighten Compression
Fittings securely.
Important: Keep thread sealant out of your waterway and prevent component
part damage! Do not use sealant on compression fittings. When thread
sealant is used, do not apply it to the first two “starter” threads.
Important: Flush dirt, debris, and sediment from the supply line(s).
