6
2917
14
2020
-
PJC 211 & 212
Setup Procedure
MC_0094
At the fi rst start-up of a new system, one of the two screens below will be shown:
Menu System Setup
System Devices
MC_0094
MC_0094
Setup
SETUP
Move between menu items with the (stern) joystick.
Press the button below
to select the highlighted menu entry.
Press the button below
to return to the previous menu.
Setting done under SETUP will be sent to all other panels in the system.
Default in systems
without stabilizers
SYSTEM DEVICES
View all devices connected to S-Link and manually change setup values.
A PIN code is required to enter the SYSTEM DEVICES menu. Use the (stern) joystick to set the pin code one
number at a time, press button below the
-symbol to jump to next number and confi rm. The pin code
is “9 9 9 9”.
The number of devices found is shown in the upper right corner of the display. Use (stern) joystick to move
between the installed devices.
The list of devices found can fi ll more than one screen. A scroll bar indicates the position of the selected item.
(NB: Re-entering the SYSTEM DEVICES menu within 15 minutes does not require re-entering PIN code.)
SETUP DO NOT MATCH SYSTEM.
PRESS
FOR AUTO SETUP
New devices found. Not in conflict with other devices.
Press button below the
-symbol to auto setup.
Thrusters can not be operated to auto setup is completed.
‘OR’
RUN SETUP! DEVICES IN CONFLICT!
Detected devices in conflict. Two or more thrusters defi ned
as same instance (bow/stern/bow STB/Stern STB). Run Setup
procedure to correct.
Thrusters cannot be operated until setup is completed.
Press and hold the button marked “MENU” for 3 seconds to enter the menu
system. Use the (stern) joystick to select “SETUP”, Press button below the
-symbol to enter the”SETUP”-menu.
Use the (stern) joystick to select “SYSTEM DEVICES”,
Press button below the
-symbol to enter the”SYSTEM DEVICES”-menu.
Use the (stern) joystick to set the pin code one number at the time,
press button below the
-symbol to jump to next number and confi rm.
The pin code is “9 9 9 9”.
(NB: Re-entering the SYSTEM DEVICES menu within 15 minutes does not require entering PIN code.)
For about 2 seconds an hourglass will appear while scanning the S-link for devices.
The devices found in the system is now displayed with their instance (thruster type and location) and
serial number.
Go through all devices and make sure that they are set to the correct instance and
function (refer to detailed instructions in the SETUP section of “Menu System”-chapter).
Press button below the
-symbol to save setting and return to “Setup”- Menu.
The setup procedure requires
knowledge of the serial number and
location of all the S-link devices.
Write this down in the form on the
last page to have the information at
hand when doing a manual setup.
2.1
1.0
2.0
2.2
2.3
2.4
