19 / 42
PRESET 1/PRESET 8
The camera goes to preset 1 or preset 8 at the end of the park
time.
PATTERN 1 ~ 4
The camera performs one of the 4 patterns at the end of the
park time (command sequence continuously performed).
CRUISE
The camera performs a cruise (preset sequence) at the end of
the park time: the camera runs a cycle of up to 30 preset
positions.
REPEAT LAST
The camera simply resumes the operation it was performing
before being interrupted at the end of the park time.
HOME N TRA
The camera goes to preset 1 and starts tracking at the end of
the park time.
CRUISE TRA
The camera performs a cruise with tracking on at the end of
park time.
SCAN SPEED <DEG/S> 1 ~ 32 DEG./S
This will specify the rotation speed for automatic horizontal
scans.
PAN SPEED
50 ~ 250 DEG/S
This is to set the pan speed of the PTZ. Value changes every
20 degree.
TILT SPEED
50 ~ 250 DEG/S
This is to set the tilt speed of the PTZ. Value changes every
20 degree.
SET SCAN
This submenu set the limits for horizontal pan movements of
the camera. The limits are long applicable in
FRAME SCAN
mode (see below).
MANUAL LIMIT
ON/OFF
If this option is ON, horizontal automatically scanning is
performed within the right and left scanning limits open.
To set the left and right scanning limit, position the camera at
the required pan angle and press
OPEN
to set.
A preset position may be called up outside these scanning
limits.
SET AZIMUTH ZERO
This sets the pan zero position (see below).
CLEAR AZIMUTH ZERO
This is used to delete the zero position settings (see below).
Table 10
SET SCAN submenu
This includes a number of settings related to the programming of horizontal
FRAME SCAN
limits.
1) Press
“
►
” on “
SET SCAN STOPS
”.
2) Press
OPEN
to confirm.
3)
Go to the required position with the joystick to set the left scanning limit.
4) Press
OPEN
to confirm.
5)
Go to the required position with the joystick to set the right scanning limit.
6) Press
OPEN
to confirm, Press
CLOSE
to cancel the operation.
7)
Point the cursor “
►
” to “
CLEAR SCAN STOPS
” and press
OPEN
to delete the programmed positions.
SET AZIMUTH ZERO submenu
This includes the settings related to programming of the pan zero position.
1)
Go to the required position with the joystick to set zero position.
2) Press
OPEN
to confirm; Press
CLOSE
to cancel the operation.
CLEAR AZIMUTH ZERO submenu
This includes the settings related to deleting the pan zero position.
1) Press
OPEN
to confirm.
2) Press
CLOSE
to cancel the operation.
4.5.3.3. POWER
UP
Screen 13: Power Up
Option
Value
Explanation
POWER UP ACTION
NONE
No action is performed at the end of power up.
POWER UP
POWER UP ACTION NONE
BACK
EXIT
