19
If the Enclosure net(9) and Jumping mat(7) are not
pre-installed, follow
the
below steps to install.
Place the Jumping mat(7) on clear ground.
Identify the warning label on mat top as shown.
the first V-ring
clip
the first hole
Enclosure net
Enclosure door
the first hole
the first V-ring
5.1
5.
Place the Enclosure net(9) on the Jumping mat(7),
make sure the first hole and the first V-ring are
aligned as shown.
5.2
Insert the first V-ring into the first hole, and then
insert the remaining V-rings into corresponding
holes in the same way one by one, until the Enclosure
Net(9) and the Jumping mat(7) are fully attached .
5.3
9
NOTE:
The first hole refers to the first one that is located
just left of the Enclosure door.
The first V-ring refers to the one which
has
a
clip on
it.
5
warning label
7
warning label
Enclosure door