24
Holes
14
9
Strap ring
Strap
12
14
Hole
17
Hole
A
14
Hexagon hole
11.
Make sure the Hexagon hole side of the cap is
against the net, and the holes on both the strap
ring and the caps are aligned.
Hold the pole cap close to a Curved Tube(12), then
Insert the Curved Tube(12) into the Pole Cap(14).
Make sure the holes on the curved tube, pole cap
and strap ring are aligned. then
Insert the M5x44mm
bolt(17)
until it touches the nut in the Hexagon hole
of the pole cap, securing them together.
Repeat this step to assemble the remaining enclosure
poles and caps.
Make sure the bent side of the enclosure poles
are facing toward the center of the trampoline.
The end of the Straight Tubes(11) are sharp.
be careful when assembling.
Repeat this process to
place
the remaining seven
poles
onto
the trampoline frame.
9
Leg
Socket
Frame Pad
B
C
Follow below steps to attach Curved tube to cap
A.
Identify the hexagon hole on the Pole Cap(14) with
a nut buried inside.
B.
Insert the Pole Cap(14) into one strap ring on the top
edge of net.
C.
12. Start from the Enclosure door, lift one of the
assembled poles and insert the Straight Tube(11)
into the vertical tube of Socket as shown.
NOTE:
12
Jumping mat
Leg
