Page 18
I5 INSTALL ● REV0
4-2. Set Up
Step 1
Open the three (3) in-house water shut-off
valves. Check for leaks and take appropriate
action.
Step 2
Ensure the four (4) Drain Hoses are placed
downward and completely in the floor sink.
Step 3
Verify the Washer Control Panel ON/OFF
switch is in the OFF position.
Step 4
Place the Electrical Main Disconnect Switch
into the ON position.
Step 5
Place the Washer Control Panel ON/OFF
switch to the ON position. The washer will
initiate a power up/self-diagnose routine and
a sequence of messages will appear on the
display window until it ends with the following
message:
Step 6
Thoroughly inspect the Water Supply Line
connections and Chemical Hoses for leaks.
Inspect the inside of the Washer through the
removed panel access ports for any signs of
failure.
Step 7
Press the STOP key. The display will continually
alternate between the following messages.
Step 8
Press the STOP key . The Soil Side Washer
Door will open. Let it go completely down.
Step 9
Press the STOP key. The Door will begin to
close. Place your hand on top of the Door. The
door should stop and begin to go down. The
following error message will appear on the
display.
Step 10
Press the STOP key. The display will return to
the Program Select sequence.
Step 11
Press the STOP key. The door will close.
NOTE
The washer will not respond to keypad
commands when the CYCLE COUNTER
window is displayed. The keypad
commands must coincide with the
Program Select window.
Step 12
When the Program Select window is displayed,
press the RIGHT ARROW key two times. The
following messages will be displayed.
