MOUNTINGTHRE REMOTE RECEIVER
First,
install (4) AA-size 1.5
ALKALINE
batteries in the remote receiver (Fig 11). For best performance, remote receiver
batteries should be factory fresh when installed. The system operates best when battery output is greater than 5.3 volts.
Four (4) new AA batteries should provide an output voltage of 6.0 to 6.2 volts.
Be sure batteries are installed with the
(+) and (-) ends facing the correct direction.
Next
, attach wall mount cover plate to receiver box (Fig. 12):
Position the receiver as shown in the diagram to the left with lower tab on wall mount cover plate inserted into groove of
receiver. Move the receiver up and snap into top tab of cover plate.
Position the cover plate so the word
ON
is facing up (Fig. 13); then, install the remote receiver into the plastic switch box
using the two long screws provided. Push the slide button over the receiver slide switch only after making sure the remote
receiver has LEARNED the transmitter’s security code (see LEARNING TRANSMITTER TO RECEIVER).
REMOT
E
O
N
O
F
F
LEARN
WALL
Plastic Switch Box
Remote Receiver
Wall cover plate
& Transmitter holder
Receiver
Slide
Button
Fig. 13. Installing receiver into switch box.
Skytech: 3301P2
REV. 5-7-12 Page 5
Remote Receiver
Cover Plate
(Rear View)
Loosen screws on back of
receiver; pull out existing wires
from receiver and insert new wire
(not supplied) from appliance
Fig. 12. Wall plate to receiver.
NOTE
: The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is
in the (middle) REMOTE position. If the system does not respond to the battery transmitter on initial use, see LEARNING
TRANSMITTER TO RECEIVER section, and re-check battery positions in the remote receiver.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace, behind the control access panel or
louvers. Position where the ambient temperature inside the receiver case does not exceed 130°F.
NOTE
: The black
Slide
Button
(included) should be installed on the receiver for Hearth Mount applications.
