PROGRAM OPERATION OF THE TRANSMITTER
This remote has two program segments: A weekday segment and a weekend segment. To enter program mode, push the
PROG
button; the word PROGRAM will appear above the display time to indicate program operation is active.
You may change any of the factory settings by following the procedures below. Should you desire to return to the factory
program, follow the procedures under heading
PROGRAM REVIEW
or
PROGRAM CANCELLATION.
Table 1: Built-in program. P1 (Programs Mornings only). P2 (Programs Evenings only)
BUILT-IN FACTORY PROGRAM
Weekends (Sat. - Sun.)
Weekdays (Mon. - Fri.)
Program
ON
OFF
TEMP
ON
OFF
TEMP
P1
6:00AM 10:00AM
72
°
F
5:00AM 9:00AM
72
°
F
P2
5:00PM 10:00PM
72
°
F
4:00PM 10:00PM
72
°
F
The user may override the program function by putting the remote in manual ON mode. When the user turns the remote
back to OFF mode, the remote will resume factory program mode (the word PROGRAM is above the display time). To turn
the program function OFF, press the PROG button. The word PROGRAM will disappear from the remote.
PROGRAMMING THE TRANSMITTER TO YOUR CUSTOM SETTINGS
1.
Program Segment: Program 1 (P1) left hand side of screen;
Program 2 (P2) right hand side of screen).
2.
Flame On: Time when you want your appliance to turn ON.
3.
Flame Off: Time when you want your appliance to turn OFF.
4.
Weekend Segment: Saturday and Sunday.
5.
Weekday Segment: Monday through Friday.
Fig. 17. Program Settings
Fig. 17 Shows LCD display program settings outlined below.
NOTE:
P1 Can only be set from 12:00AM (midnight) to 12:00PM (noon)
P2 Can only be set from 12:00PM (noon) to 12:00AM (midnight)
Skytech: 3301P2
REV. 5-7-12 Page 8
1
2
3
4
5
The transmitter built-in program is exactly the same for each weekday and weekend day. If desired, you may change a
the weekend or weekday settings of the built-in program. Use the blank table on the next page and fill in your customized
settings. You
cannot
change individual days, only the entire weekend or weekdays. To change the transmitter programs
open the front cover and complete the following steps:
NOTE:
Program times are in 15-minute segments.
Step 1:
Press the
PROG
button and hold for 5 seconds, the
program section of the LCD screen will begin to flash.
Step 2:
P1 “ON” (flame icon) and “S S” (weekend segment) will be
flashing. Select the time you want your appliance to turn ON
by using the UP and DOWN buttons. Then press
SET
button (See Fig. 18).
Step 3:
P1 “OFF” (flame icon crossed out) will be flashing. Select
the time you want your appliance to turn OFF. Then press
SET
button (See Fig. 19).
Step 4:
The set temperature will begin to flash. Use the UP and
DOWN buttons to select a temperature for P1, then press
SET
button (See Fig. 20)
Fig. 18. Flashing weekend segments,
time, P1 and flame “ON” icon
Fig. 19. Flashing weekend segments,
time, P1 and flame “OFF” icon
