Glue this assembly to the scribed lines on C19.
Sand a groove in the bottom of C9 that will fit the 3/16 control
rod as shown.
Cut a piece of 3/16" dowel to 1-1/8" to use as a control stick
and glue to C9
Sand the corners of C9 as shown
Glue C50 to the dowel assembly and glue the assembly to
the dowel on the cockpit floor as shown. It should be cen-
tered between the rudder pedals C6.
Align and glue the C12 seat mounts to the cockpit floor and
F8A on the scribed lines.
Glue the seat to the C12's so it is centered with the control
stick.
Sandwich C45 between two C46's and glue the assembly to
the cockpit floor on the right side of the seat (to the scribed
lines).
Glue C27 to F8A. This part extends straight up.
