Cockpit:
The cockpit should be installed after your plane is painted
and/or covered. You can paint the pieces before they are in-
stalled or after if you are careful. Note: many of the photos
show the cockpit assembled outside the airplane for clarity.
Paint C19 & C8. If you use a brush, use a couple light coats
of paint so you can retain the laser engraving on each piece.
Trim the gauge lens plate to the same size as C8. Use foam
safe CA, wood glue or canopy glue to glue the gauge lens
plate to C8.
Cut the gauge paper to the approximate size of the C8 as-
sembly. Align the gauges to the holes and glue as shown
with foam safe CA, wood or canopy glue. Do not get glue on
the gauges themselves.
Set assembly aside and allow to dry.
Cut the gauge backing piece to size and align with the holes
in C19. Glue in place with CA, wood or canopy glue.
Set aside and allow to dry.
