Fit the F35 wing hold down plate into the slots in F23 and
epoxy in place. Use some balsa tri-stock to reinforce as
shown.
Sand the sides of the fuselage around the wing saddle and
make sure the F23 wing saddle is flush with all the formers.
Cut a piece a 1/16" x 4" x 36" to 20". Cut another piece to 2"
and edge glue it to the first piece. Repeat for the other side.
Sheet the forward part of the fuselage from F1B to F11. This
sheeting will butt up to the top sheeting.
Cut and sand the sheeting to match the wing saddle and
F1B, F2B
Vertical Stab:
Align and glue V1 to V2
Align and glue V3-V6 to the scribed lines in the V1,V2 as-
sembly.
Turn over and align V3-V6 to the ribs on the opposite side
and glue in place
