Align and glue the sheeting to the fuselage crutch. Wet down
sheeting with ammonia/water mixture and continue to sheet
the fuselage working both sides evenly.Trim the sheeting
around the cockpit area making sure to keep about 2" of
sheeting aft of F4A. This area will be needed in order to fit
the canopy correctly.
You will probably need to make a few small cuts around the
areas with compound curves in order to fit the sheeting.
Trim and sand the sheeting as shown.
**Electric version**
Remove the fuselage from the board and turn upside down.
Cut two pieces of 3/8" x 3/8" Basswood to 4-7/8". Align them
to the slots in F3A thru F5A.
It should butt against F2A and
not extend past F5A.
