KYJACK, Page 10
JIII eries
ection 5 - Procedures
ervice and Maintenance
h e g r e e n L E D
i.
w i l l t u r n o n s o l i d .
Results:
he switch
is ready for normal
operation.
10. urn main disconnect switch to “
” off
position.
11. Remove jumper wire between #7 and #19 from
terminal block.
12. Reattach all wires #02 to motor contactor.
13. Reinstall any covers that was removed.
14. Remove chock or wheel blocks.
15. Proceed to est and Verify ilt Circuit.
Test and Verify Tilt Circuit
ed LED
Gree
n LED
Light Indicators
Set up button is located on this
face next to harness
Operations of Tilt witch
he following describes the LED’s and what they
indicate.
Green LED
Illuminated whenever both tilt
axes are within the specified
degrees of the zero/ home
learned position.
Flashes when transitioning in
or out of tilt angle limits, but
built in time delay has not fully
occurred.
Red LED
Illuminated whenever tilt on one
or more axes is more than the
specified degrees out from the
zero/ home position.
Green & Red LED
On together, no blinking when
fault detected.
Tilt Circuit Test
1.
Refer to section 2 for test tilt sensor procedure.
ed LED
Green LED
