KYJACK, Page 9
JIII eries
ection 5 - Procedures
ervice and Maintenance
Reprogramming Existing Tilt witch
ed LED
Gree
n LED
Light Indicators
Set up button is located on this
face next to harness
1.
Ensure aerial platform is parked on a firm level
surface.
2.
Chock or block wheels to keep the aerial platform
from rolling forward or backward.
3.
Lower/Raise the platform and secure the scissors
using the maintenance bar. (Refer to Operating
manual for Maintenance Support Procedure)
NOTE
he tilt circuit is only powered when
activating a function.
4.
Remove any covers to locate and view the tilt
switch.
5.
Disconnect all wires #02 from motor contactor.
6.
Install jumper wire between #7 and #19 to
terminal strip.
7.
urn main disconnect switch to “ ” ON position.
8.
Verify switch is powered. (Red or green LED will
be continually blinking)
9.
Reprogram the Tilt witch
Press and hold the set
a.
up button for 3 seconds.
Results:
Both LEDs will
be OFF.
Both LEDs will flash.
b.
impORTANT
Step “c” must be completed within
a 5 second period, or the switch will
automatically exit program mode and
return to normal operation using previously
stored data.
Press and release set up button 3 times.
c.
If 5 second period has expired prior
d.
completion, repeat Step “a”, “b” and “c”.
Observe program delay
e.
/ stabilization time.
(Only the red LED will
blink for 4 seconds)
B o t h L E D s w i l l
f.
flash for 1 second.
Results:
he switch is
learning the new zero
position.
Both LEDs will turn
g.
on solid for 1 second.
R e s u l t s :
h e n e w
zero position has been
learned.
he green LED will flash and then the
h.
red LED will turn on solid for 2 seconds.
Results:
he switch is verifying the new
zero position.
ed LED
Green LED
ed LED
Green LED
ed LED
Green LED
ed LED
Green LED
ed LED
Green LED
ed LED
Green LED
ed LED
Green LED
ed LED
Green LED
ed LED
Green LED
