The navigation announcements can be repeated by pressing the right control-
ler
2
» Fig. 1
on page 7
.
The timing of the navigation announcement depends on the type of road and
the driving speed. For example, on motorways the first announcement is heard
about 2000 m (6000 ft) before the location of the motorway exit.
During dynamic route guidance, the unit notifies the driver of traffic problems.
If a new route is calculated due to a traffic obstruction a corresponding mes-
sage appears in the devices screen
Calculating the route…
It is possible to set the output volume of the navigation announcements, the
type of announcement or turning off during a phone conversation
» page 62
,
Navigation announcements
.
Route
If a calculated route to your destination is available and in the menu
Naviga-
tion
the function key
Route
is pressed - then the following route option is
displayed.
■
Stop route guidance
- Stops route guidance
■
New dest./stopover
- Enter a new destination or add a destination to the
calculated route
» page 63
or
» page 73
■
Route information
- Display information about the destination and the calcu-
lated route (setup of information displayed
» page 62
)
■
- Arrival time at destination/stopover
1)
■
- Remaining travelling time to destination or stopover
1)
■
- Remaining travelling distance to destination or stopover
■
Store destination
- Stores the destination on the input screen
» page 11
,
Alphanumeric with keyboard
■
Tour
- display of tour destinations
» page 73
■
Congestion ahead
- at identified traffic disruptions (e.g. traffic jam) these
traffic disruption can be entered manually (after this entry the device per-
forms a new data calculation and offers an alternative route. The traffic jam
information increases or decreases by touching the scale
/
or by turning
the right control
2
» Fig. 1
on page 7
.
Traffic Information (TMC)
Introduction
This chapter contains information on the following subjects:
Operation
72
Dynamic route switch on / off
73
Traffic report details
73
The TMC traffic reports (Traffic Message Channel) provide a transmitted radio
data service for continuous transmission of traffic reports.
The TMC traffic reports are used to optimise the route during route guidance
when there are traffic disruptions.
The following conditions are required for the correct TMC function.
The vehicle is within reception range of the FM RDS-TMC.
Adequate and uninterrupted signal reception of a traffic information sta-
tion.
Current navigation data in the device.
The radio stations broadcasting this information are responsible for the con-
tent of the TMC traffic reports.
Operation
›
Press
- a list of traffic reports
Traffic report …/…
is displayed.
›
Touch a traffic report entry - it traffic report details are displayed
» page 73
.
If a TMC traffic radio station is available for current location, the TMC traffic re-
ports are updated continuously in the background. The station you are listen-
ing to does not have to be a TMC station.
The reception of TMC traffic reports is always switched on and cannot be
turned off.
TMC traffic reports can only be evaluated and saved by the radio navigation
system when navigation data are available for the driven area.
1)
If the time of arrival or remaining travelling time is greater than 24 hours,
is displayed inside the sym-
bol.
72
Navigation
Summary of Contents for Infotainment Navigation Amundsen
