SKF 396-0946, User And Maintenance Instructions, Page: 8 / 44

) See list of approved and recommended lubricants ( † page  ). Contact Lincoln if lubricant is not in list.
) Lubricant output is measured at + °F (+21 °C) and backpressure   psi (100 bar) . Different pressures, temperature and grease can change output results.
Table 
Specifications
Electrical data for V pump
Incoming voltage  V –%/+%
Maximum current  A
External fuse  A (time delay)
Reverse polarity protection Yes
Current draw with pump off  mA
Electrical data for V AC pump
Incoming voltage  to  V AC
Maximum current . A
Frequency  to  hz
Output from power supply  V at  A
External Fuse  A (time delay)
Common electrical data for V and V AC pump
Minimum count  count
Maximum count ,
Pause count increments  count
Maximum pumping time  minutes
Enclosure rating IP KK (NEMA X)
Rating for fault relay contact:
Switching voltage
Maximum  V AC/ V AC/ V
Switching current Maximum  A inductive
Minimum switching current . mA
Pump PS
Operating pressure with:
–pressure switch
  psi (240 bar)
–pressure transducer   psi (240 bar)
Transducer can be adjusted from   to   psi (96 to 317 bar)
End of line pressure switch setting   psi (172 bar) (not adjustable)
End of line pressure transducer setting   psi (172 bar) (not adjustable)
End of line transducer vent pressure is factory preset at  psi (62 bar) . Pressure can be adjusted from  to   psi (14 to 70 bar)
in  psi (6,9 bar) increments.
Maximum distance using shielded wire for pressure transducer  ft (30 m)
Operating temperature range for DC pumps – to + °F ) (340 to +70 °C) )
Operating temperature range for AC pumps  to  °F ) (0 to 50 °C) )
Number of outlets (see instructions) 
Lubricant Up to NLGI grade  )
Output . in  /min ) (24.6 cm 3 /min) )
Reservoir sizes, L , ,  and 
Lubricant line connection size G  /

in
Pump elements K
Piston diameter  /

in (7 mm)
Number of pumping elements (connected together) 
Tightening torques:
Install pump
. lbf-ft (18 Nm)
Electric motor on housing . lbf-ft (12 Nm)
Pump element in housing . lbf-ft (20 Nm)
Closure plug in housing . lbf-ft (12 Nm)
Return line connector on housing . lbf-ft (12 Nm)
Tie rods for  and  l reservoir . lbf-ft (10 Nm)
