skcinc.com
Form 37169 Rev 210311
Page 4
GETTING STARTED
Charging the Battery
Set up the charging train (Figure 2a or 2b as applicable) and completely charge the battery before
operating the dosimeter.
See Determining Battery Charge Status. Note: Cat. Nos. 701-001K3,
701-001K3-C, 701-001K5, and 701-001K5-C feature a carry case with charging cable installed to charge
dosimeters inside the case. See Charging Train in Carry Case with Charging Cable Installed and
Figure 2b.
1. Prepare the charging dock (1-unit Charging Dock Cat. No. 701-002 or 5-unit Charging Dock Cat.
No. 701-003).
See Figure 2a.
a. Insert the power supply Cat. No. 220-600 into the power jack on the back of the charging
dock.
b. Plug power supply cube into 100-240 V power supply. The power LED on the back of the
dock will light up blue when connected to the power supply.
Note: You can also charge
NoiseCHEK by connecting the charging dock to your PC or a USB battery bank with a
USB cable. Charging time may increase significantly depending on the power available
from the USB port used.
2. Place the NoiseCHEK in the prepared charging dock. Battery charging status
bars will be displayed on the dosimeter screen (
see right
); five amber LEDs will
blink during charging. Full charge is indicated by five green blinking LEDs.
Note: When the battery is fully charged, LCD (display) will shut down. The green
LEDs will continue blinking while the dosimeter remains in the charging dock.
Figure 2a. Charging Train
100-240 V
Wall outlet
Power jack
(on back)
Power supply
NoiseCHEK
1-unit Charging Dock
5-unit Charging Dock