WARNINGS
Failure to read and understand the information provided in this manual may result in personal injury or death, damage to
the product or product failure. Please read each section in its entirety and be sure you understand the information provided
in the section and related sections before attempting any of the procedures or operations given.
Failure to follow these precautions could result in serious injury or death.
Keep these instructions with warranty after installation. This product must be
installed in accordance with National Electrical Code, ANSI/NFPA 70 so as to
prevent moisture from entering or accumulating within the controller housing.
ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing this product.
A qualified service person must install and service this product
according to applicable electrical codes and electrical schematics.
EXPLOSION OR FIRE HAZARD
Do not use this product with flammable liquids. Do not install in
hazardous locations as defined by National Electrical Code,
ANSI/NFPA 70.
•
Do not install in area with: excessive or conductive dust, corrosive or
flammable gas, moisture or rain, excessive heat, regular impact shocks
or excessive vibration.
•
Do not place in water or let water leak onto the controller.
•
Do not allow debris to fall inside the unit during installation.
•
Double-check all the wiring before turning on the power supply.
•
Do not touch live wires.
•
Stay as far as possible from high-voltage cables and power equipment.
•
Leave a minimum of 10 mm space for ventilation between the top and
bottom edges of the controller and enclosure walls.
