21
SW Rest Secure System™ Set-Up
Basic Set-Up
WARNING:
Electric shock may occur when plugging the SW Rest Secure
System™ into the wall outlet. Use ONLY grounded or hospital grade outlets.
DO NOT use the SW Rest Secure System™ if the power cord is cut, frayed or
loosely connected to the bed.
Make sure the unit is plugged into AC power and the hand control is connected to the bed’s
footboard. The Nurse Call Interface cable at the head of the bed should be securely plugged into
the Nurse Call Interface on the wall to function properly. Press the enter button to activate the
hand control.
The first photo shows the unit operating on AC power. The second photo shows the unit
operating on battery reserve power with full charge. The third photo shows the battery reserve
with 15% charge.
10:00 Ma y 18,20 10
REST
SYSTEM
SECURE
S
WEIGHT 0 LBS
AC Power
10:00 Ma y18, 20 10
REST
SYSTEM
SECURE
S
250 LBS
Battery 100% Charge
Low Battery Warning
10:00 Ma y18, 20 10
REST
SYSTEM
SECURE
S
250 LBS
x
The unit will go into standby after 60 seconds of inactivity. If this occurs press any button,
except back, to resume.
CAUTION:
To ensure reliable functionality, the battery reserve should only be
used as a temporary power source until AC power is restored. When the Low
Battery Warning screen is shown, the unit should be plugged into AC
immediately.
Bed Exit Alarm
The nurse call is always active no matter what selection is made. When selecting nurse call only,
the audio alert will be disabled in the room. This unit will chime on an alarm if a voice message
has not been recorded and the unit is set to Voice Recording.
1. Access the Menu by pressing the UP or DOWN arrow until Bed
Exit Settings is highlighted and then press ENTER.
2. Select Set Alert Type and then press ENTER
