sitrex MK14 MY15, Assembly

Page: 25 / 38

25
28) DANGER
Extend the hose 1 along the drawbar until the female end is near bracket A. Connect
the female end of hose 1 to the T coupling 2. Connect the elbow couplings 3 to the T
coupling 2. The assembled hose and couplings unit 1-2-3 are placed underneath
bracket A so that the couplings 3 are at the back of it. Now fasten the flow divider 4
and the hose and couplings unit 1-2-3 to bracket A using bolts 5, bracket 6 and nuts 7.
Note: bracket 6 must hold hose 1 on the rubber part of the hose just behind the steel
bushing B at the end of the hose.
Hose 1 will also be in the following steps.
In this step, you will use:
Item 1: 1 hose, ½”, length 7850mm (309.1”)
Item 2: 1 male T coupling, ¾”, JIC 37°
Item 3: 2 male-female elbow couplings, ¾”, JIC 37°
Item 4: 1 flow divider
Item 5: 2 bolts M6x60 (0.47”-2.36”)
Item 6: 1 hose support
Item 7: 2 nuts M6 (0.24”)