sitrex MK14 MY15, Assembly

Page: 14 / 38

14
13) DANGER
Attach the wheel supports 3-4 to sections 1-2
(RH-LH) using bolts 5 and nuts 6.
Apply grease nipples 7 to the seats in wheel
supports 3-4.
In this step, you will use:
Item 5: 12 bolts M16x45 (0.63”x1.77”)
Item 6: 12 nuts M16 (0.63”)
Item 7: 2 grease nipples M8 (0.31”)
14) DANGER
Insert the nylon bushings 5 into the openings
in support 1-2 (RH-LH). Place spacer 4 on
the pins of the wheel units 3. Insert the
wheel units 3 into the openings in sections 1-
2. Attach the flange 6 onto the pins of the
wheel units 3 using the spring pin 7.
Before continuing make sure that the wheel
units 3 can turn freely.
Attach the plate with bolt 8 underneath
flange 6. Attach the counterplate 9 over
flange 6, inserting the counterplate pins A
into the holes in the plate with bolt 8 and
into holes B in the supports 1-2. Place the
bushing 10, spring 11 and washer 12 over
the plate 8 bolt and put nut 13 on the bolt.
Note: the more spring 11 is compressed by
tightening nut 13, the more the turning of the
wheel is braked, therefore check that it is
adjusted properly when the machine is to be
operated (see machine use).
14) DANGER
In this step, you will use:
Item 4: 2 spacers ø50-76x5 (1.97”x3”)
Item 5: 4 nylon bushings ø50-60x50 (ø1.97”-2.36x1.97”)
Item 7: 2 spring pins ø10x80 (0.4”x3.15”)
Item 10: 2 bushings ø13-18x20 (0.5”-0.71”x0.79”)
Item 11: 2 springs ø5-30x45 (0.20”-1.18”x1.77”)
Item 12: 2 washers ø12-36x4 (ø0.47”-1.42x0.16”)
Item 13: 2 nuts M12 (0.47”)