Round Baler ACTION 120
USE AND MAINTENANCE MANUAL - 36 -
- Check all nuts and bolts are properly tightened;
-
Restore the chains’ correct tension;
- Check for leaks in the hydraulic circuit and make
sure the drives are working properly;
- Check the tires pressure;
- Check
the
lubrication
of
transmission
components.
6.5 EVERY 8 HOURS OF USE
- Check the general state of the round baler.
- Perform the complete greasing operation,
lubricating all the points marked by the
«lubricating nipple» sticker and any points
subject to friction.
The following checks are to be repeated at regular
intervals and, in all cases, at the beginning of
each season:
-
Check the reduction gear’s oil level and, where
necessary, top up.
- Perform the complete greasing operation,
lubricating all the points marked by the
«lubricating nipple» sticker and any points
subject to friction.
-
Restore the chains’ correct tension.
- Check all nuts and bolts are properly tightened.
- Make sure the electrical system is working
properly.
- Check for leaks in the hydraulic circuit and make
sure the drives are working properly.
- Check the tires pressure.
6.6 EVERY 24 HOURS OF USE
Every 24 working hours, lubricate and grease all
the rolling parts subjected to frictions and
particularly:
- Rear door cylinders joints.
- Main pressing arm cylinders articulations.
- Pick-up drums articulations.
- Rear door articulations.
- Tensioned joints.
- All the greasing points..
6.7 AFTER THE FIRST 50 HOURS OF
USE
After the first 50 W.H. change gear-box oil
following the procedure mentioned on paragraph
6.8.
6.8 EVERY 50 HOURS OF USE
Every 50 W.H. or even more frequently check the
gearbox oil level through the inspection window.
Lubricate the cardanic transmission according to
the quantities and the methods indicated in the
cardan shaft manual.
6.9 EVERY 400 HOURS OF USE
Every 400 W.H. change the gearbox oil with oil
type Agip BLASIA 220, the required amount is
about 2lt.
To do it is necessary to:
- Unscrew the filling up plug.
- Put a tank under the gearbox to bring the
exhausted oil.
- Unscrew the drain plug making sure that the
used oil flows into basin.
- When the operation is completed, tighten the
drain plug.
- Unscrew the level plug and introduce the new oil
through the filler plughole. A correct level should
touch the lower edge of the level plughole.
- Screw the level plug and the filling up plug.
Pic. 27
– Gearbox
6.10 LUBRICATION
The lubrication of any machine featuring rotating
components and/or parts rubbing against each
other is of great importance in assuring the lasting
service life and proper working of the actual
machine. Hence, lubrication should be performed
systematically at regular intervals.
CAUTION
The greasing points on the machine are
indicated with the «ingrassatore» sticker (par.
2.3). Before injecting lubricating grease
through the grease nipples, it is necessary to
clean the grease fittings to prevent mud, dust
or foreign bodies from mixing with the grease,
reducing or even canceling the lubrication
effect. Avoid introducing too much lubricating
grease
into
the
grease
nipples.
The
introduction at the greasing point of a large
quantity of grease with high pressure can
damage the bearing guards. Perform this
operation with caution.
Use a coat of anti-rust over any abraded areas.
