Round Baler ACTION 120
USE AND MAINTENANCE MANUAL - 32 -
- Start the tractor gradually with the round baler
attached until reaching the right work speed.
This varies depending on the type of product
but between 5 and not over 12 km/hours.
- Near the binding pressure, however, limit the
speed of advancement to obtain the best
result.
- Start the binding after the buzzer sound and
red light come on. Continue to collect the
product until twine or net has begun to wrap
the bale.
- Stop the tractor and wait the binding end.
- Once the binding has been completed, reduce
the rotation speed and open the rear door.
- The bale leaves the pressing chamber,
possibly moved by the ejector (optional).
- Once the bale has been unloaded, activate the
rear gate closure, pressurizing the closing
cylinders again;
- The round baler is now ready for the next bale
formation. In case of very large windrows, is
advisable to limit the feed speed and increase
the speed of the cardan shaft.
5.13 ADJUSTING ROUND BALE
DENSITY
The round baler features a manually adjustable
graduated rod (Pic. 23), so that the compactness
of the bales can be adjusted to suit the Pick-up
requirements. If this lever is set in the down
position (green), the bale is softer, whilst the up
position (red) produces more compact bales.
Pic. 23
– Density adjustment
5.14 PICK-UP HEIGHT ADJUSTMENT
The pick-up is equipped with wheels for adjusting
the height (4°, Pic.1)
To adjust the wheels:
1- Loosen the screws for fixing the wheel
supports
2- Using the hydraulic control, position the
pick-up at the desired height.
3- Push the wheels on the ground and
fasten the screws.
5.15 PICK-UP WITH ADJUSTABLE
WHEELS (OPTIONAL)
Pic. 24
– Adjustable Pick-up wheels
