Sitecom WLM-4601, User Manual

Page: 26 / 71

may already be configured.
ATM QoS : Select CBR to specify fixed (always-on) bandwidth for voice or data traffic.
Select UBR for applications that are non-time sensitive, such as e-mail. Select VBR for
burst traffic and bandwidth sharing with other applications.
PCR : Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell
Rate (PCR). This is the maximum rate at which the sender can send cells.
SCR : The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted.
MBS : Maximum Burst Size (MBS) refers to the maximum number of cells that can be
sent at the peak rate. Type the MBS, which is less than 65535
Encapsulation:
Select the encapsulation type your ISP uses from the Encapsulation list. Choices vary
depending on what you select in the Mode field. If you select Bridge in the Mode field,
select 1483 Bridged IP. If you select Routing in the Mode field, select PPPoA, 1483
Bridged IP, 1483 Router IP or PPPoE.
PPPoE/PPPoA
User Name : Enter the user name exactly as your ISP assigned.
Password: Enter the password associated with the user name above.
Encapsulation : select Bridge in the Mode field, select either PPPoA or RFC 1483. Select
Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or PPPoE.
Multiplex : Select the method of multiplexing used by your ISP. Choices are VC or LLC.
Connection : The schedule rule(s) have priority over your Connection settings.
Always on : Select Always on Connection when you want your connection up all the
time.
Connect on Demand : Select Connect on Demand when you don't want the connection
up all the time and specify an idle time-out in the Max Idle Timeout field
Get IP Address : Choose Static or Dynamic
Static IP Address : Enter the IP address of ADSL Router in dotted decimal notation, for
example, 192.168.1.254 (factory default).
IP Subnet Mask : The default is 255.0.0.0. User can change it to other such as
255.255.255.0.Type the subnet mask assigned to you by your ISP (if given).
Gateway : You must specify a gateway IP address (supplied by your ISP) when you use
1483 Bridged IP in the Encapsulation field in the previous screen.
Network Address Translation : Select None, Many to One or Many to Many from the
drop-sown list box. Refer to the NAT chapter for more details.
RIP Version : Select the RIP version from RIP-1, RIP-2B and RIP-2M.
RIP Direction : Select the RIP direction from None, Both, In Only and Out Only.
Multicast : IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a Multicast group - it is not used to carry user data.