Sitecom WLM-4601, User Manual

Page: 30 / 71

Allow : Only allow the wireless clients with the MAC Address you have specified can
access to the router.
Deny : The wireless clients with the MAC Address you have specified will be denied
accessing to the router.
MAC Address : Enter the MAC Address of the wireless clients for the filtering control.
When you finish, click „Submit‟ to save the settings made and restart the router so the
settings will take effect after it reboots.
Advanced Wireless
This page allows advanced users who have sufficient knowledge of wireless LAN. These
setting shall not be changed unless you know exactly what will happen for the changes
you made on your router.
Transmit Power : Set the maximum output power of the router. The higher output
power, the wider the coverage range is.
Beacon Interval : The interval of time that this wireless router broadcast a beacon.
Beacon is used to synchronize the wireless network. The range for the beacon period is
between 20 and 1024 with a default value of 100 (milliseconds).
RTS/CTS Threshold: This value should remain at its default setting of 2347. Should you
encounter inconsistent data flow, only minor modifications are recommended. If a
network packet is smaller than the preset “RTS threshold” size, the RTS/CTS mechanism
will not be enabled. The wireless router sends Request to Send (RTS) frames to a
particular receiving station and negotiates the sending of a data frame. After receiving an
RTS, the wireless station responds with a Clear to Send (CTS) frame to acknowledge the
right to begin transmission.
Fragment Threshold : Fragment Threshold specifies the maximum size of packet during
the fragmentation of data to be transmitted. If you set this value too low, it will result in
bad performance. Enter a value from 256 to 2346.