3.2.10. Fitting the Piping on the Outer Side of the Wall withOutlet
-
From box 2 – installation accessories, remove the plastic square outlet with a damper and square plastic
outlet without the damper.
-
Apply MS polymer-based sealant along the whole perimeter of the chamfered edge of the socket to seal
the gap between the outlet socket and the tube.
-
Fit the outlet with the damper to the lower tube.
-
Fit the outlet without the damper on the upper tube.
-
Align the dampers according to the flatness of the facade and fix them as needed (e.g. by cementing them
to the facade)
-
Fig.24
-
Correct sealing between the damper socket and piping ensures correct condensate drainage through the
outlet.
3.2.11. Installation of the Front MetalCover
-
Bolt in the M6x20 bolts with the plastic head (part of the delivery, in a bag) about 10 mm to the bottom
of the unit.
o
Xroom 100 size – 2 pc
o
Xroom 250 size – 3 pc
-
Remove the front cover of the unit from box 1 – "Xroom unit".
-
Hook the unit cover behind the unit body and, at the same time, attach it to the partially bolted M6x20
bolts with plastic head. The side edge of the unit cover shall be positioned in alignment with the side edge
of the installation template to form a "one edge".
-
Tighten with your hand the partially tightened M6x20 bolt with the plastic head.
1
APPLY CEMENT AROUND THE ENTIRE OUTLET
SOCKET PERIMETER – TWICE
INSERT THE OUTLETS INTO PIPES
2
UPPER
WITHOUT
LOWER
WITH
REMOVE THE FRONT COVER
FROM THE PACKAGING
1
PARTLY TIGHTEN THE BOLTS
2
32
Version 1 – GBR(23/06/2021)
D-502-0152