SIP SILVERCUT DISC 300 TS FC, Instruction For Work

Page: 117 / 138

Instruction for work
24
3.2 Adjusting the cutter bar to the lateral tilt
The limited flexibility of the cutter bar holder (1) and
the centrally mounted bar enable the optimal
adaptation to the terrain and protection of the drives.
–
The maximum angle of the adjustment of the cutter
bar to the terrain is

8º.
– The oscillation of the cutter bar on the holder is
relieved with two springs (2).
– A limited adjustment angle ensures a long lifespan
of the drives.
–
Check the middle position before
starting mowing in order to prevent the
overloading of the cutter bar in upward
inclinations (material damage).
–
It is recommended to grease the spring
guides (2)!
3.3 Adjusting the tension of the tines-kneading
machine
The tines-kneading machine has adjustuble flap for
adjusting the intensity which increases and reduces
the space between the flap (1) and rotor tines (2).
The fodder dries faster if the kneading intensity is
higher.
– Adjusting the tension of the tines-
kneading machine as well as
elimination of stoppings and obstacles
must be performed with the switched
off drive and stand still engine! Remove
the ignition key.
Adjusting the flap of the tines-kneading machine:
–
Pull out the pin (4) and set the lever (3) into the
position (A) – flap slightly opened – higher intensity
– or to position (B) – opened flap - lower intensity.
– Loosen the pin (4) to let it stuck in the position
hole.
– Adjust the tines-kneading machine
intensity according to fodder quantity:
–
Much fodder = more opened flap (B).
– Average fodder = flap in middle
position.
– A little fodder = more closed flap (A).
–
In case of stoppings open the flap
more.
21
2
2
1
22
1
2
3
4
A
B