SINO SDS6, Operation Manual

Page: 19 / 117

A. Basic Function
10
0
2
error.
）
4
）
Find the mechanical origin
There are two methods for setting the compensation origin.
1
、
directly press to choose the current position as origin.
2
、
Press to choose the 1st absolute zero of the raster ruler as the
mechanical origin.
Move towards the positive direction of X axis of the
machine tool and search for the 1st absolute zero of the raster ruler as the
mechanical origin. After find the origin, then auto enter the next step for data input.
This time the X-axis displays the raster ruler fact value, the laser value is inputted
from Y-axis.
5) Input the compensation setup of the 1
st
segment
Move towards the positive direction of
X axis of the machine tool until get to the
place of compensation.
Press
（
When press ,Y-axis will displays the X-axis’s value, and that means the
compensation value has been setup. If the value input is wrong, don’t move the
raster ruler, and press ,then press , this time the digit-display LED of
Y-axis will be in input state, and input the right value again.
）
Press , and enter into the next set-up point
Remarks: In this function, the display of X
axis is the coordinate value, while Y axis
displays the standard value or the
measurement value by laser
6) Input the compensation setup of the 2nd segment
Press
Press , enter into the next set-up point
0
2
Y
X
1
coordinate value
The standard value or the
measurement value by laser
Y
X