37
5.5 The Function of measure for taper
The taper of work piece can be measured
when turning the taper work piece.
Operation:
As figure shows, the nod of lever meter
is touched the position A of work piece surface.
Pressing it to make the lever meter point to zero.
1) Then entering the function of measure
for taper.
Press
2) Move the lever meter to position B of
work piece surface, press it to make the
lever meter point to zero.
3) Compute.
Press
，
Obtain taper and angle
4) Quit
Press
key
5.6 200 tool storeroom
It will need to use different tools when turning different work pieces or
different surface of work pieces, so it is necessary to uninstall and adjust the
tools, SDS6 digital readout has the function of 200 tools storeroom, which
makes the operation simple.
Notice: The function of 200 tools storeroom can’t be used but the
lathe has the frame of adjusting tool. Please don’t use this function if you
haven’t the frame of adjusting tool.
1
、
Set a base tool. In the state of “ALE”,
to clear the display value of the X axis
or the Y axis when moving the base
tool to touch the frame of adjusting tool.
Summary of Contents for SDS 2-3VA
Page 1: ...LCD DIGITAL DISPLAY SDS 2 3VA OPERATION MANUAL...
Page 6: ...1...
Page 53: ...V1 0 202110...
