Sindoh A1 Series, User Manual

Page: 91 / 133

Pour all remaining resin into a clean bottle. If resin is not flowing down well, use rubber scrapper
enclosed in the finishing kit to scrap down resin.
If too much force is applied to the scrapper, film can stretch or tear. Scrape the surface of film softly.
After pouring is done, remove all remaining resin inside of the resin tank using Isopropyl alcohol (IPA)
and paper towel, and then clean up IPA using dry paper towel.
- Never use Isopropyl alcohol (IPA) or ammonia-based cleaner to clean the bottom of the resin tank.
- In the bottom of resin tank, there is a transparent window made of Acryl (PMMA). Acryl (PMMA)
material can cause chemical reaction with some type of chemicals such as IPA, ammonia-based
cleaner, etc, so that window will be broken or deformed.
- Be sure to use a dedicated cleaner for acryl material to clean the transparent window.
- Do not place a bottle containing resin in a place where light source exists. Resin will be cured due
to the light.
Rubber Scrapper
4 Printed Output Check