Sinclair GSH-100ERA series, Operational Manual

Page: 7 / 64

AIR-TO-WATER HEAT PUMP INSTALLATION MANUAL
★ Please note whether the
installation stand is firm
enough or not.
If
damaged, it may cause fall of
the unit and injury of people.
★ unit should be installed at
the place with good ventilation
to save
energy.
★ When there is not
water in water tank, never
power the unit on to run.
Notice!
1
、
Before installation, please check if the adopted power is accordance with that listed
on nameplate, and check the safety of power.
2
、
Before using, please check and confirm if wires and water pipes are connected correctly to
avid water leakage, electric shock or fire etc.
3
、
Don’t operate the unit with wet hand, and don’t allow children to operate the unit.
4 、 The On/off in the instruction is for the operation to on and off button of PCB for users; cut off
power means to stop supplying power to the unit.
5
、
Don’t directly expose the unit under the corrosive ambient with water or dampness.
6
、
Don’t operate the unit without water in water tank .The air outlet/inlet of unit can not be
blocked by other objects.
7 、 The water in unit and pipeline should be discharged if the unit is not in use, to prevent the
water tank, pipe line and water pump from frost-cracking.
8
、
Never press the button with sharp objects to protect manual controller. Never use other
wires instead of special communication line of the unit to protect control elements. Never
clean the manual controller with benzene, thinner or chemical cloth to avoid fading of
surface and failure of elements. Clean the unit with the cloth soaked in neutral
eradicator .Slightly clean the display screen and connecting parts to avoid fading.
9
、
The power cord must be separated with the communication line.
If there is any question, please contact with local dealer, authorized
service center, agencies or our company directly.
！
5