Operating Manual TRACSCAN 2.0
V2.0, 2022-05
7 / 36
3.
Quick Guide
1.
Select Measurement Location and Prepare Instrument
Choose your location based on the measurement task. Ensure that all drive wheels are dry
and free of dust or sand. Clean the wheels with a damp cloth and dry them before staring
a measurement.
2.
Select and Prepare Test Foot
Depending on the measurement task, select the right test foot (SBR. leather, etc.). If nec-
essary, prepare the test foot (see section [Preparation] on how and why to prepare the
test foot). Insert the prepared test foot in the underside of the instrument.
3.
Prepare Test Path
If a wet measurement shall be taken, create a wet test path with enough width and length
for the entire test distance. For details refer to the requirements of the method, see sec-
tion [3.6.4].
4.
Place Instrument
Place the instrument on the walkway surface / test tile, pointing in the desired direction.
Ensure that the instrument can move along the entire path without obstruction.
5.
Start Measurement
Start the measurement by pressing button1 or button 2.
Start program 1; default is: DCOF, 15 cm, scale NFSI B101.3
Start program 2, default is: SCOF, 5 samples, scale NFSI B101.1
6.
Optional Location Code
If the location code feature is enabled, the user is prompted to enter a location code that
identifies the measurement location. See section [3.5] for the location code feature.
7.
Optional Paper Printout
Once the measurement has been completed, press the Print button to print out the meas-
urement results.
Print results from most recent measurement.
8.
Remove Test Foot and Put Back Instrument
In order to protect the instrument and the test foot from damage, remove the test foot from
the instrument after use.
The wheels’ rubber rings are made of a special anti-slip material. As they leave marks on the
surface, put the instrument back in its case.