Operating Manual TRACSCAN 2.0
V2.0, 2022-05
24 / 36
The tool shall be used as follows:
1.
Depending on the test method, ensure that the tool has 400 or 600 grit sandpaper in-
stalled.
2.
Take off the circular cover by pulling up on the red knob and black handle at the same
time.
3.
Push the red knob towards the black handle until it clicks and insert the test foot with the
cut off edges facing to the left or right.
The correct arrangement is crucial
, see images
below.
Figure 12: Test Foot OK
Figure 13: Test Foot Wrong
4.
Gently re-insert the circular cover into the tool. Push the red knob away from the black
handle until it stops.
5.
Turn the black handle clockwise about 5 times and then counterclockwise 5 times. Check
the surface so that no plain parts or notches are visible.
6.
Gently remove the circular cover. Repeat step #2 above.
7.
Remove the test foot by pushing the red knob away from the black handle to release the
test foot.
