Simrad IS40 PRO, Operator'S Manual, Page: 16 / 32

14 |
Setup | IS40 PRO Operator Manual
Setup
Sources
A data source can be a sensor or a device connected to the
network, providing information and commands to other networked
devices. The data sources are normally configured at first time turn
on. It should only be necessary to update this data if a new source is
added, source is missing (sensor failure), source has been enabled/
disabled, sensor replaced or a network reset.
Auto select
The Auto select option will look for all sources connected to the
instrument system. If more than one source is available for each
item, the display will automatically select from the internal device
priority list.
1.
Verify that all interfaced units are powered on.
2.
Press the
Enter
key to start the auto select procedure.
The operator will be noted when the auto select process is
completed.
¼
Note:
If more than one source is available on the network, you can
chose your preferred source from the sources menu. See Manual
source selection.
2