Simrad FM90, Reference Manual

Page: 28 / 140

26
922-00027001/2.2
Procedure
1 On the Processor Unit, close the FM90 software.
2 Open the
Network and Sharing Center
dialog box.
a In the bottom-left corner of your desktop, type “network and sharing center” into
the Cortana search box, then press
Enter
.
Observe that the Control Panel opens.
b On the left-hand menu, select
Change adapter settings
.
c Click once on your network adapter to select it, then right-click and select
Properties
on the short-cut menu.
d On the list of connections, select
Internet Protocol 4 (TCP/IPv4)
, and then
Properties
.
3 Select
Use the following IP address
, and type the IP address and network mask.
IP Address:
192.168.1.N
( "N" can be any number from 1 to 254, except 234, which is
the Sonar Head default. )
Subnet mask:
255.255.255.0
You can leave
Default Gateway
blank.
4 Click
OK
to save the settings, then close all the dialog boxes.
Starting operation of the Sonar Head
To start operation of the FM90 sonar, you may need to verify that the Sonar Head has
been discovered.
Context
Note
After powering up the FM90, there will be a brief delay before the Processor Unit discovers
the Sonar Head. The length of this delay depends on external factors, such as the length of
your third-wire trawl cable. Wait for the VDSL/STATUS light on the Power/VDSL Unit to
turn solid green before attempting to connect to the Sonar Head.
Procedure
1 Double-click the FM90 icon on the Processor Unit desktop to start the software.
Simrad FM90 Reference Manual