CR44/54 Introduction and safety summary
Chapter 1-5
1.3.2 Radar and radar functions
RADAR
Press the
[RADAR]
key to call up the radar display in full screen.
Press again to toggle between the radar shortcut series
- see chart examples in section 1.3.1.
To start the radar
1. Press [ENT], [RADAR] to initiate a warming up period of two minutes
(countdown of 120 seconds), and then the radar will go in Standby mode.
2. Press [ENT], [GOTO] to start transmission.
Select and adjust radar range
Press one of the numeric keys 1 - 9 to select a fixed range. Key
9
will select
the largest range and key
1
the smallest. Use the +/- keys to adjust range in
smaller steps.
ENT
Press [ENT] to call up the Radar quick menu with access to e.g.
Show active navigation point on radar screen, activate EBL/VRM
cursors, etc.
EBL
The EBL1/VRM1 cursors can also be toggles on/off directly from
the [EBL] key.
CLR
Turn off cursor. Long press on [CLR] will turn off all active cursors.
ADJ
The [ADJ] key will open for adjustments of the radar parameters.
Use the cursor or the [ADJ] key to move around in the control panel;
toggle between available values with the +/- keys or enter new values
with the numeric keys. Press [ENT] to exit control panel.
In the Dual Radar display: after pressing the [ADJ] key to access the
the control panel for making adjustments, only half of the parameters
will be visible. By pressing [ADJ] again will toggle between the 1st
and 2nd half of the control panel.
