Simpro MegaDumper, User Manual

Page: 17 / 60

User Manual // Simpro MegaDumper®
Original Instructions // English // v86.0 // February 2022 // Page
16
a. The safety system will now conduct an auto-diagnostic check. If no faults are
detected, the blue light will go out and the machine will be enabled.
a. If the safety system detects a fault, the blue light will not go out and the
machine will be disabled. The fault must be found and corrected before the
machine can be used, as per
§4.10 .
6. Press the RAISE button once . The cradle will automatically lift, hold the bin inverted for
a short time, then return to ground level.
Press the EMERGENCY STOP button to stop the cradle at any time.
7. Open the door and remove the empty bin as per §2.2 .
8. Repeat from step 1) as required.
Once the cradle has lowered, the door is automatically unlocked for about 15 seconds. If
the door re-locks, press the LOWER button to unlock it at any time.
2.3.5.2 MANUAL mode
1. Before operation, check that the machine is stable and safe to use as per §2.1 .
2. Open the door. If the door is locked, press the LOWER button to unlock it.
3. Place the full bin onto the cradle, taking care that it is properly positioned as per §2.2 ,
then shut the door.
4. Turn the mode-selector switch to MANUAL.
5. Press and hold the blue RESET button for two seconds.
a. The safety system will now conduct an auto-diagnostic check. If no faults are
detected, the blue light will go out and the machine will be enabled.
b. If the safety system detects a fault, the blue light will not go out and the
machine will be disabled. The fault must be found and corrected before the
machine can be used, as per
§4.10 .
6. Press and hold the RAISE button until the bin reaches the inverted position, then
release. Wait for the contents of the bin to empty.
Release the RAISE/LOWER button or press the EMERGENCY STOP button to stop the cradle
at any time.
7. Press and hold the LOWER button until the cradle rests on the ground.
8. Open the door and remove the empty bin as per §2.2 .
9. Repeat from step 1) as required.
Once the cradle has lowered, the door is automatically unlocked for about 15 seconds. If
the door re-locks, press the LOWER button to unlock it at any time.